First you need.
Re felting a large shed roof.
Ensure the mating surfaces is clean and dry they apply adhesive to the damaged area and the underside of the repair patch.
I had to re felt my shed roof so i though i d share with you the process i went through and the materials i used.
Clean the roof decking of any debris protruding nails or other objects.
If you have a small spit or hole in a shed roof it can also be repaired with the felt adhesive mentioned above.
Since you will have overlap.
After you ve cut the right sized felt and nailed it at 10cm intervals pulling it tight so that it lies flat along the length of the shed roof.
The first step in felting a shed roof either angled or flat is calculating the exact.
The original fascia barge boards will then be refitted.
Dry the roof surface.
Hi guys and welcome to my video.
New fascia barge boards can also be supplied if required.
A conventional roll of felt is enough for 432 square feet.
The existing fascia barge boards will be taken off and the old felt removed.
Buy the roof felt.
Grab loose pieces of felt and pull them off the roof.
Clean and prepare the.
For most sheds you ll need to cut 3 pieces of felt.
The process of felting a shed roof step 1.
You ll need enough felt to cover the entire area of the roof with a little extra on each edge around 5cm to allow for overlaps at the eaves and at the gable ends approximately 7 5cm.
We offer a re felting service for sheds summerhouses and workshops.
We will then re felt with either our standard duty or premium duty felt as shown below.
This will enable you to move about with ease.
Re felt your shed roof step 1.
Unroll your shed felt onto a clean and dry surface.
Remove old felt from the roof with your hands and a putty knife.
Shed roofs are not normally designed to support a fully grown man especially when in such a.
Gently scrub the roof using a bristle.
This allows it to relax after.
Clean and tidy up the area especially the floor around the outside of the shed.
Nail along the bottom edge of the roof hammering it in at wider intervals around one every 30cm.
I documented this project with my gopro being small and tough i could keep it in my.
