Remote Control Ceiling Fan Light Wont Turn Off

Turn off the ceiling fan using the remote.

Remote control ceiling fan light wont turn off.

The bad news is the fan canopy must be dropped to access the receiver. It is controlled by a remote control only no switch. However the light on the fan works and the remote does control the light. But if you have a unit that has both a light and a fan the wall switch will usually turn off both of them.

I tried replacing the battery for the remote already and i tried turning off the power to the house. Typically there is also a wall switch. The process will change the frequency settings and allow the remote to work again. You will also find a corresponding set of dipswitches on the fan.

You can use that to turn the fan on and off. When i turn the power back on the fan goes back on. Hunter fan remote reset follows the same steps making the troubleshooting easy. For 10 seconds hold down the off button.

Make sure the blue wire from the receiver is wired to the blue or black with white stripe if a hunter from the fan. If the lights are still stuck on at this point it is time to replace the receiver. If the above does not resolve the issue continue to the following steps to check for over heating. Generally you ll need to open the housing to find it.

This will sync the ceiling fan remote with the receiver. The first step is to see if the remote was faulty. If the fan sometimes turns on by itself off by itself or the light kit does this on it s own then this is a good sign you do need to change the dipswitches. Dipswitches are toggle switches on the back of the remote.

Typical ceiling fan remote control modules are located above the ceiling fan support bracket in the ceiling. If you want to stop the fan but still use the light you have to use the pull cord or the remote. Reset the fan remote. Run the ceiling fan for a few minutes.

The remote module has a set of small dip switches on the side of the module. The fan is on and won t turn off. Reset the remote of your fan. Wait for 30 seconds before turning the fan on again.

Clean and lubricate the ball bearings. Turn off the ceiling fan and allow the blades to come to a full stop. One of the wires from the ceiling should be capped off usually the red one. Change the switch setting to match the settings of the hand held remote control.

Replace the ceiling fan capacitor. My ceiling fan will not turn off. If you want to reset the remote. Turn on the power from the mains.

Turn of your fan using its dedicated remote control. To determine the cause of the fan speed malfunction follow the steps below. Open the battery cover of your remote control under the battery will be a set of dip switches match the dip switch code from your old remote to the new remote test to see if the lights can be turned off. If your ceiling fan won t turn on or your speed settings are not working properly you may notice a sharp change in the airflow.