Removing Roof Shingles For Reuse

The look will not be altered if you reuse shingles that are already on the roof.

Removing roof shingles for reuse.

Plug any tears with roofing cement and reuse. If the shingles fail at any point during that time span expect a check for a prorated amount. Push them down the roof so they fall into the trash bin. Push the shingles down to the roof jacks.

Remove shingles in a 2 to 3 ft wide section as you work down the roof. The other advantage of reusing shingles that have been removed either by hand or some natural phenomenon is the appearance of your roof. Attach with nails along the top edge of the strip. Using new shingles could alter the appearance of your roof if you cannot find the exact shingle that is already on there.

Use a starter strip or cut pieces for a starter course. Very carefully remove the old shingles. Removing tar from a roof installing new shingles is a major investment for most homeowners so it makes good sense to take steps to protect the integrity of the roof for as long as possible. Beginning at the peak slide the scraper under the top layer of shingles and pry them off.

Continue tearing off the shingles and underlayment until you reach the roof jacks then start over at the top of the roof. Climb onto the roof with a shingle scraper. You guys think it s ok to reuse the existing shingles because they match the other shingles as long as you put a new nail next to the old nail hole and also fill in the old nail hole with a new nail and fill that over with roofing silicone. Four years is old enough to not match with new but will last a long time.

Laminated versions carry a lifetime warranty which means for as long as you own the house or for a maximum of 40 to 50 years. The shingles will roll up like a ball in front of the fork. When removing shingles to address a roof leak and applying ice and water shield to the decking do. This helps ensure your kansas city home continues to be protected from the elements.

Rip cut the starter strip or starter pieces so that they butt up against the second course of existing shingles and are even with the front edge of the existing roofing.