How to fix small dents in aluminum siding drill a hole in it.
Repairing aluminum siding dents.
Place a washer on.
Hopefully the dent will pop out and the siding will be.
Pop any dents out of the aluminum siding by first drilling a 1 8 inch hole in the center of the dent with a power drill.
Next pull on the screw with a pair of pliers.
Use a 1 8 inch bit or a similar size.
Drill a couple of 1 8 inch holes in the part of the siding that contains the dent.
Depending on the dent and body.
Apply heat with your source of choice.
The next steps include.
Use caution if you are standing on a ladder.
If the damaged piece can be removed they might be able to turn it over and gently bang out the dent.
It doesn t take a lot.
Attach a washer to the end of a 1 inch self tapping screw and then insert the screw into the drilled hole.
Pull back on the plunger to straighten the dent.
You want it where it s deepest.
Evaluate the technique you want to use.
Aluminum siding used to be all the rage some 25 years ago but now the more modern vinyl siding has followed in its footsteps.
Play pause space step 2.
Grab the washer with pliers and pull to remove the dent.
Dampen a rag in water.
Disconnect battery and any other electronics in the repair area.
Learning how to repair a hole in aluminum.
Wipe down the aluminum trailer s dent to get it moist.
Use pliers to pull the dent halfway up.
Using sandpaper take off all the paint.
Place a plunger against the dent and push down to create suction.
Select a sheet metal screw slightly wider than the hole you ve drilled.
How to repair a dent in an enclosed aluminum trailer step 1.
Sanding sponges work.
It will start changing right away as stress is released.
The foregoing not withstanding aluminum siding is a singularly durable exterior product and those whose homes are ensconced are loath to give it up.
Wipe off the sanding dust with a rag wipe the siding again with a damp sponge to pick up finer particles and dry the siding with a clean rag.
Drill a small hole in the center of the dent.
Here s what to do.
Place a flat washer onto a sheet metal screw and then screw it part of the way into one of the holes you drilled.
Depending on the colour of the siding it may be difficult to match.
Heat up the damaged area.