Replacing worn or damaged awning material is an easy diy job aussie conditions are hard on awning material.
Replacing torn awnings.
Do note this step is for small holes or tears that are below three inches only.
For the smaller hopes the first step is to find a suitable patching material which will need to be ordered from a specialty online retailer.
To do so measure from the center of one arm to the center of the other.
Remove the bolts securing.
This will give you a 2 inch reinforced repair on all sides of the rip.
Here are the things you re going to need in this step.
Use rv awning repair tape.
If the hole in the awning is less than eight inches you may be able to patch it.
First unlock the safety lock and turn the roll to remove some.
Pick the spring assembly up and slide it back into the roller tube.
A cleaning solution waterproof glue repair tape.
This is the fabric size you need to order.
Next choose your new awning fabric.
Reinsert the spring assembly and the pop rivets.
Place the vise grip back onto the bolt.
Measure for the correct awning replacement fabric.
Replace a damaged awning step 1.
Clamp the vise back on and rotate it the same amount as before.
Release some of the tension on the awning roll.
For rips in the body of the canvas awning cut a piece of replacement fabric that is 4 inches wider and 4 inches longer than the rip.
Fit a pin to lock the torsion assembly so the tension is not released when assembly is later removed.
Do not measure the fabric itself.
However anything larger than that is likely just going to need to replaced with a completely new awning cover.
How to replace torn rv awning in 5 easy steps step 1.
Sailrite sells all the materials you need to make your own replacement retractable awning panel.
Most rv awnings are made of either acrylic or vinyl material.
The usually vinyl material cops a lot of uv light and heat and will degrade over time.
Reassembling the awning 1.
You can easily replace your retractable awning s fabric with a brand new sunbrella awning.