Move to the highest end of the valley and work your way down cleaning shingles from both sides of the valley whether they re damaged or not.
Repointing roof valley.
A properly flashed roof valley should have an ice and water shield installed with roofing felt being properly secured over the ice and water.
How to repair a crack in a wall.
Category general diy videos tags re point lead valley lead roof valley.
If the ice and water shield is missing then you will have to remove the shingles on both sides along the valley put ice and water shield in place and re shingle the roof.
Repointing is basically a waste of time money what you should do is take out all the cement and re bed the tiles if done properly should last at least ten yrs.
This video shows how to re point the lead valley on a tiled roof safely using fibre reinforced mortar.
Check the entire roof valley carefully to locate the source of these problems.
Cut each side of the flashing at the lower end to conform with the corresponding edges of the roof using sheet metal cutters.
Clear any debris in the roof valley and surrounding area.
Take measurements of your roof flashing most flashing is 14 inches wide but yours may vary.
Cut each side at the upper end of the valley to conform with the.